Note You must be administrator to configure network settings. Configuring Network Settings Network Pane.This section describes how to change the network settings, and contains the following topics: After you initialize the sensor, you can make any changes and configure other network parameters in Sensor Setup.įor the procedure for running the setup command, see Chapter 18 "Initializing the Sensor." Configuring Network Settings You can continue using Advanced Setup in the CLI to enable Telnet, configure the Web Server, and assign and enable virtual sensors and interfaces, or you can use the Startup Wizard in the IDM. With the setup command, you configure basic sensor settings, including the hostname, IP interfaces, access control lists, global correlation servers, and time settings. Configuring Authentication and Users Understanding InitializationĪfter you install the sensor on your network, you must use the setup command to initialize it so that you can communicate with it over the network.This chapter contains the following sections: This chapter provides information for setting up the sensor. Adding, Editing, Deleting Users, and Creating Accounts.Add and Edit User Dialog Boxes Field Definitions.RADIUS Authentication Functionality and Limitations. The Service Account and RADIUS Authentication.Configuring the Sensor to Use an NTP Time Source.Configuring a Cisco Router to be an NTP Server.Configure Summertime Dialog Box Field Definitions.Verifying the Sensor is Synchronized with the NTP Server.Synchronizing IPS Module System Clocks with Parent Device System Clocks.Allowed Hosts/Network Pane and Add and Edit Allowed Host Dialog Boxes Field Definitions.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |